![]() For additional information, please select your iDRAC 6 firmware and then documentation for iDRAC 6 User's Guide. When the connection mode is configured for "Direct Connect Basic Mode", the server will allow IPMI utilities such as ipmish.exe to run IPMI commands over the serial port. When the connection mode is configured for "Direct Connect Terminal Mode", the server will allow the user to type IPMI commands to the server. When the BIOS is configured correctly, and Serial Console Redirection is being used, the user has the ability to press " + + 9" key sequence to activate IPMI Serial mode. Breakout mode is configured for IPMI Serial by default.The iDRAC IPMI and RAC Serial settings should match this setting. SOL can be disabled and the SOL BAUD Rate setting will still be used to configure the Serial Console Redirection speed. Use the Serial Over LAN Baud Rate Setting to modify the Serial Console Redirection speed.Use the SOL BAUD Rate Setting in the iDRAC configuration to modify the Serial Console Redirection BAUD rate. ![]() The Failsafe BAUD Rate Setting should not be changed.Console Redirection can be used via COM1 or COM2 as long "Serial Device 2" is configured for the same address. Breakout mode can be configured for IPMI or RAC mode by configuring the iDRAC settings. If Breakout mode is required, then configure the BIOS External Serial Connector setting to use "Serial Device 2".
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |